• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
RAPID ENGINE WARM-UP-cont. - TM-9-2320-365-10_500
PREPARATION FOR MACHINE GUN OPERATION

/.5tonv1-2/TM-9-2320-365-10 Palletized Load System Model M1074/M1075 NSN 2320-01-304-2277 2320-01-304-2278 Manual
Page Navigation
  448    449    450    451    452  453  454    455    456    457    458  
TM 9-2320-365-10 CAUTION Time limits must be followed to prevent overheating.  Failure to comply may result in damage to equipment. NOTE In the event of a tachometer failure a HAND THROTTLE lever positioned to L is approximately 1,250 to 1,450 rpm. (6)   Set engine speed to 1,250 to 1,450 rpm or place HAND THROTTLE lever (7) to L for two minutes maximum. (7)   Set engine speed to idle (750 rpm) or place HAND THROTTLE lever (7) to full down position. (8)   Select N for NEUTRAL (8) on WTEC II TEPSS (6) or WTEC III TPSS (6) and allow engine to idle (750 rpm) for two minutes minimum. NOTE •  Vehicle  performance,  including  heater/defroster,  will  be  reduced  when engine operating temperature is between 100  F to 165  F (38  C to 74 C). Avoid conditions requiring maximum performance until WATER TEMP gage reaches 165  F (74  C). •  If WATER TEMP gage does not show 165  F (74  C) within 20 minutes, notify Unit Maintenance. (9)   Repeat steps (5) through (8) until WATER TEMP gage (9) reaches 165  F (74  C) maximum, or 100  F (38  C) minimum to begin driving. All data on pages 2-380 through Change 1 2-379/(2-380 Blank) 2-404, including pages 2-381 through 2-404 deleted.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.