• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CAB TILT AND SPARE TIRE RETAINER
MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION - TM-9-2320-365-10_532

/.5tonv1-2/TM-9-2320-365-10 Palletized Load System Model M1074/M1075 NSN 2320-01-304-2277 2320-01-304-2278 Manual
Page Navigation
  474    475    476    477    478  479  480    481    482    483    484  
TM 9-2320-365-10 Table 3-2.   Troubleshooting MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION NOTE If corrective action does not correct malfunction, notify Unit Maintenance. a.   ENGINE SYSTEM a1. ENGINE DOES NOT CRANK. Step 1.    Check to see if battery cables and terminal posts are OK. (a) Remove battery box cover (para 3-8a). (b) Check battery cables for damage and corrosion. If corrosion is present or battery cables are damaged, notify Unit Maintenance. (c) Check terminal posts for corrosion. If corrosion is present, notify Unit Maintenance. Step 2.    Check fluid level in battery cells (para 3-8b). If fluid level is low, notify Unit Maintenance. If fluid level is not low, notify Unit Maintenance. (a) Install battery box cover (para 3-8c). a2. ENGINE CRANKS BUT DOES NOT START. Step 1.    Check fuel level. (a) Position master power switch to on (para 2-1a). If fuel gage shows fuel level at or below E (empty), fuel vehicle (para 2-20a). (b) Position master power switch to off (para 2-1a). Step 2.    Is fuel/water separator primed? (a) Raise cab (2-22a). (b) Depress button on fuel/water separator as many times as necessary until button is tight. (c) Attempt to start engine (para 2-21a or b). If engine cranks but does not start, notify Unit Maintenance. (d) Lower cab (para 2-22b). a3. LOW ENGINE OIL PRESSURE. Step 1.   Check for proper engine oil level. (a) Raise cab (para 2-22a). Change 1 3-15







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.