• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
HIGH ENGINE TEMPERATURE INDICATOR DOES NOT ILLUMINATE
TURN SIGNAL INDICATORS AND HIGH BEAMS ON INDICATOR DO NOT ILLUMINATE

/.5tonv1-2/TM-9-2320-365-10 Palletized Load System Model M1074/M1075 NSN 2320-01-304-2277 2320-01-304-2278 Manual
Page Navigation
  499    500    501    502    503  504  505    506    507    508    509  
TM 9-2320-365-10 Table 3-2.   Troubleshooting (Cont) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION e.   ELECTRICAL SYSTEM (CONT) e24. CHEMICAL DETECTOR INDICATOR DOES NOT ILLUMINATE (CONT). (c) If circuit breaker is tripped, push in to reset. (d) Position main light switch to SER DRIVE (para 2-21c). (e) Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance. (f) Position main light switch to OFF (para 2-21c). (g) Install PDP cover (para 3-13b). (h) If chemical detector indicator still does not illuminate, notify Unit Maintenance. e25. LEFT TURN SIGNAL INDICATOR DOES NOT ILLUMINATE. Step 1.   Check operation of turn signals (para 2-15, item 21). If turn signals do not illuminate, go to step 2.   If turn signals are ok, notify Unit Maintenance. Step 2.   Check for illumination of high beam indicator (para 2-21c). If high beam indicator does not illuminate, perform Electrical System Troubleshooting (e27. Turn Signal Indicator And High Beam Indicator Do Not Illuminate). Step 3.   Check circuit breaker (CB74) in PDP to see if it is tripped. (a) Remove PDP cover (para 3-13a). (b) Position main light switch to OFF (para 2-21c). (c) If circuit breaker is tripped, push in to reset. (d) Position main light switch to SER DRIVE (para 2-21c). (e) Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance. (f) Position main light switch to OFF (para 2-21c). (g) Install PDP cover (para 3-13b). (h) If left turn signal indicator still does not illuminate, notify Unit Maintenance. e26. RIGHT TURN SIGNAL INDICATOR DOES NOT ILLUMINATE. Step 1.   Check operation of turn signals (para 2-15, item 21). If turn signals do not illuminate, go to step 2.   If turn signals are ok, notify Unit Maintenance. Step 2.   Check circuit breaker (CB74) in PDP to see if it is tripped. (a) Remove PDP cover (para 3-13a). (b) Position main light switch to OFF (para 2-21c). 3-40 Change 1







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.