TM 9-2320-365-10Table 3-2. Troubleshooting (Cont)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTIONp1. HARD TO STEER (CONT).Step 3. Check that steering reservoir is filled to proper level. Oil should be level with full mark ondipstick.(a) Add oil as required (Appendix F).(b) If oil level is over full mark, notify Unit Maintenance.(c) If vehicle is still hard to steer, notify Unit Maintenance.Step 4. Lower cab (para 2-22b).p2. WANDERS, PULLS TO ONE SIDE, OR SHIMMIES.Step 1. Check wheel studs and lugnuts for obvious looseness.WARNINGNotify Unit Maintenance that lugnuts need to be tightened to 415-475 lb-ft(563-644 N·m) as soon as possible. Wheel may come loose if lugnuts arenot tightened to proper torque. Failure to comply may result in seriousinjury or death to personnel.If loose, tighten.Step 2. Check for bent or broken studs and missing or loose lugnuts.Step 3. Check tire pressures with tire gage for each CTIS setting.(a) Notify Unit Maintenance if tire pressures do not match those given below:ALLMODELSHWY Mode 55 psi (379 kPa)X-C Mode 33 psi (228 kPa)SAND Mode 20 psi (138 kPa)EMER Mode 14 psi (97 kPa)Change 1 3-70.7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business