Change 1 2-137
TM 9-2320-365-34-1
RESISTANCE TEST
(1) Remove control valve module (para
7-10).
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to internal wiring harness 24-pin connector
pin G2.
(4) Connect negative (-) probe of multimeter
to internal wiring harness 24-pin connector
pin F3 and note reading on
multimeter.
(5) If resistance is less than 300 ohms or
greater than 2000 ohms, replace
transmission internal wiring harness
(para 7-13).
(6) Install control valve module (para 7-10).
