Change 1 2-199
TM 9-2320-365-34-1
RESISTANCE TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter to
pin A of A solenoid connector.
(3) Connect negative (-) probe of multimeter to
pin B of A solenoid connector and note
reading on multimeter.
(4) If resistance is less than 2.5 ohms or
greater than 5.0 ohms, replace A solenoid
(para 7-8).
(5) If resistance is between 2.5-5.0 ohms,
replace WTEC II TEPSS (TM 9-2320-365-
20-3).
(6) Connect internal wiring harness
connector A to A solenoid connector.
(7) Install cover on control valve module with
four screws.
(8) Install control valve module (para 7-10).
(9) Connect batteries (TM 9-2320-365-20-3).
