• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, AND/OR 45 SUB CODE 14 (PRIOR TO SERIAL NUMBER 6510032369)        (CONT) - TM-9-2320-365-34-1_352
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, AND/OR 45 SUB CODE 14 (PRIOR TO SERIAL NUMBER 6510032369)        (CONT) - TM-9-2320-365-34-1_354

/.5tonv1-2/TM-9-2320-365-34-1 M1078 Series 2-1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  308    309    310    311    312  313  314    315    316    317    318  
Change 1          2-269 TM 9-2320-365-34-1 CONTINUITY TEST CAUTION Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact.   (1)  Set multimeter to ohms.   (2)  Connect positive (+) probe of multimeter         to connector P119-V.   (3)  Connect negative (-) probe of multimeter to         external wiring harness 24-pin connector         pin C2 and note reading on multimeter.   (4)  If continuity is not present, replace         transmission external wiring harness         (para 6-7).   (5)  Connect positive (+) probe of multimeter         to connector P119-V.   (6)  Connect negative (-) probe of multimeter to         all other pins in connector P119 and note         reading on multimeter.   (7)  Connect negative (-) probe of multimeter to         ground and note reading on multimeter.   (8)  If continuity is present, transmission         external wiring harness is shorted; replace         transmission external wiring harness         (para 6-7).   (9)  Connect connector P119 to connector         J119. (10)  Position front grille on cab with washer         and screw. (11)  Position two washers and screws in front         grille. (12)  Tighten screw to 48-60 lb-in. (5-7 N·m). (13)  Tighten two screws to 24 lb-in. (3 N·m).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.