• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN        CODE 41, 42, 44, AND/OR 45 SUB CODE 16 (PRIOR TO SERIAL NUMBER 6510032369)        (CONT
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN           CODE 41, 42, 44, 45, AND/OR 69 SUB CODE 21 (SERIAL NUMBER 6510032369           AND HIGHER)

/.5tonv1-2/TM-9-2320-365-34-1 M1078 Series 2-1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  382    383    384    385    386  387  388    389    390    391    392  
TM 9-2320-365-34-1 Change 1          2-343 RESISTANCE TEST CAUTION NOTE Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. (1)  Set multimeter to ohms. (2)  Connect positive (+) probe of multimeter to       E solenoid connector pin A. (3)  Connect negative (-) probe of multimeter to       E solenoid connector pin B and note       reading on multimeter. (4)  If resistance is less than 2.5 ohms or       greater than 5.0 ohms, replace       E solenoid (para 7-7). (5)  If resistance is between 2.5-5.0 ohms,       replace WTEC II TEPSS (TM 9-2320-365-       20-3). (6)  Connect internal wiring harness connector E       to E solenoid connector. (7)  Install cover on control valve module with       four screws. (8)  Install control valve module (para 7-10). (9)  Connect batteries (TM 9-2320-365-20-3).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.