Change 1 2-491TM 9-2320-365-34-1CONTINUITY TEST(10) Position front grille on cab with washerand screw.(11) Position two washers and screws in frontgrille.(12) Tighten screw to 48-60 lb-in. (5-7 N·m).(13) Tighten two screws to 24 lb-in. (3 N·m).(1) Set multimeter to ohms.(2) Connect positive (+) probe of multimeterto P119-H.(3) Connect negative (-) probe of multimeterto external wiring harness 31-pinconnector pin F and note reading onmultimeter.(4) If continuity is not present, replace transmission external wiring harness (para 6-7).(5) Connect positive (+) probe of multimeterto connector P119-H.(6) Connect negative (-) probe of multimeterto all other pins in connector P119 and note reading on multimeter.(7) Connect negative (-) probe of multimeterto ground and note reading on multimeter.(8) If continuity is present, transmissionexternal wiring harness is shorted;replace transmission external wiringharness (para 6-7).(9) Connect connector P119 to connectorJ119.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business