• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 43 SUB CODE 26 (SERIAL NUMBER 6510032369 AND HIGHER) (CONT)
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 43 SUB CODE 26 (SERIAL NUMBER 6510032369 AND HIGHER) (CONT) - TM-9-2320-365-34-1_614

/.5tonv1-2/TM-9-2320-365-34-1 M1078 Series 2-1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  568    569    570    571    572  573  574    575    576    577    578  
Change 1          2-527 TM 9-2320-365-34-1 CONTINUITY TEST CAUTION Use care when disconnecting wiring harness connectors. Failure to comply may result in damage to equipment. (11)  If continuity is present, transmission         internal wiring harness is shorted; replace         transmission internal wiring harness         (para 7-13).   (1)  Remove control valve module (para 7-10).   (2)  Remove four screws and cover from         control valve module.   (3)  Disconnect internal wiring harness         connector N from N solenoid.   (4)  Set multimeter to ohms.   (5)  Connect positive (+) probe of multimeter         to internal wiring harness 31-pin connector         pin g.   (6)  Connect negative (-) probe of multimeter         to internal wiring harness connector N         pin A and note reading on multimeter.   (7)  If continuity is not present, replace         transmission internal wiring harness         (para 7-13).   (8)  Connect positive (+) probe of multimeter         to internal wiring harness 31-pin connector         pin g.   (9)  Connect negative (-) probe of multimeter         to all other pins in internal wiring harness         31-pin connector and note reading on         multimeter. (10)  Connect negative (-) probe of multimeter         to ground and note reading on multimeter.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.