Change 1 2-613
TM 9-2320-365-34-1
RESISTANCE TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to pin 1 of transmission turbine speed
sensor.
(3) Connect negative (-) probe of multimeter
to pin 2 of transmission turbine speed
sensor and note reading on multimeter.
(4) If resistance is less than 200 ohms or
greater than 400 ohms, replace
transmission turbine speed sensor
(para 6-5).
(5) If resistance is between 200-400 ohms,
replace WTEC III transmission ECU
(TM 9-2320-365-20-3).
(6) Connect internal wiring connector TSS to
turbine speed sensor.
(7) Install cover on control valve module
with four screws.
(8) Install control valve module (para 7-10).
(9) Connect connector P67 to adapter cable
31-pin connector.
(10) Connect batteries (TM 9-2320-365-20-3).
