Change 1 2-731
TM 9-2320-365-34-1
CONTINUITY TEST
(1) Set multimeter to ohms.
(2) Connect positive (+) probe of multimeter
to internal wiring harness feed-through
connector pin C2.
(3) Connect negative (-) probe of multimeter
to internal wiring harness connector C
pin B and note reading on multimeter.
(4) If continuity is not present, replace
transmission internal wiring harness
(para 7-13).
(5) Connect positive (+) probe of multimeter
to transmission feed through connector
pin C2.
(6) Connect negative (-) probe of multimeter
to all other pins of transmission feed-
through connector and note reading on
multimeter.
(7) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(8) If continuity is present, transmission
internal wiring harness is shorted, replace
transmission internal wiring harness
(para 7-13).
