TM 9-2320-365-34-2
21-4. ROTATING CLUTCH MODULE REPAIR (CONT)
(28) Inspect thrust bearing (17) for scoring and damage.
(29) Inspect clutch assembly (18) for scuffing, nicks, and
burrs.
(30) Measure spline wear on clutch assembly (18), maximum
distance between splines 0.015 in. (0.381 mm).
(31) Measure bushing (19), maximum inside diameter of
bushing is 3.901 in. (9.909 cm).
(32) Inspect shaft (20) for cracks, nicks, and scuffing.
(33) Measure inside diameter of bushing (21), maximum
diameter 0.795 in. (20.193 mm).
c. Assembly.
NOTE
Apply lubricating oil to all parts during
assembly.
(1) Install bushing (1) in gear (2).
(2) Install two seals (3) on gear (2).
(3) Install sealring (4) on C2 piston (5).
(4) Install sealring (6) on C1 piston (7).
(5) Install C1 piston (7) in C2 piston (5).
(6) Install C2 piston (5) on gear (2).
(7) Install thrust bearing (8) in gear (2).
21-26