TM 9-2320-365-34-2
NOTE
Perform step (5) if backlash reading is less
than 0.008 in. (0.203 mm).
(5) Loosen adjusting ring (3) on back side of hub body (4)
and tighten adjusting ring (5) facing the ring gear (2) to
increase backlash.
NOTE
Perform step (6) if backlash reading is
greater than 0.018 in. (0.457 mm).
(6) Tighten adjusting ring (3) on back side of hub body (4)
and loosen adjusting ring (5) facing the ring gear (2) to
decrease backlash.
(7) Repeat steps (2) through (6) until backlash is between
0.008-0.018 in. (0.203-0.457 mm).
(8) Tighten four screws (6) on differential bearing caps (7)
to 132-169 lb-ft (179-229 N·m).
(9) Install two cotter pins (8) in bearing caps (7).
WARNING
Front axle differential carrier weighs
approximately 350 lbs (159 kgs). Attach
a suitable lifting device prior to moving.
Failure to comply may result in injury to
personnel or damage to equipment.
NOTE
Step (10) requires the aid of an assistant.
(10) Remove differential carrier (9) from differential carrier
repair stand.
End of Task.
Change 1 23-19/(23-20 Blank)
