D-46. DIMMER SWITCH TEST WIRE
Fabricate the dimmer switch test wire according to the following steps. Refer to the following parts list for materials.
National Stock Number
12 in (305 mm)
Pin, Grooved, Headless
a. Dimensions are in inches (millimeters).
b. Cut a length of electrical wire approximately 12 in. (305 mm) long.
c. Remove approximately 1/4 in. (6 mm) of insulation from each end of electrical wire.
d. Crimp headless grooved pin on one end of electrical wire.
e. Crimp electrical contact on opposite end of electrical wire.