TM 9-2320-365-34-2
3-3. ENGINE ASSEMBLY REPLACEMENT (CONT)
NOTE
Perform steps (75) through (98) on vehicles
equipped with 100 Amp alternator.
(75) Position terminal lugs TL5 (93), TL6 (94), TL60 (95), and
TL2 (96) in clamp (97).
(76) Remove screw (98) and washer (99) from alternator (5).
(77) Position clamp (97) on alternator (5) with washer (99)
and screw (98).
(78) Tighten screw (98) to 80 lb-in. (9 N·m).
(79) Remove self-locking nut (100) and washer (101) from
voltage regulator (102).
(80) Position terminal lug TL110 (103) on voltage regulator
(102) with washer (101) and self-locking nut (100).
(81) Tighten self-locking nut (100) to 20 lb-in. (2 N·m).
(82) Position boot on terminal lug TL110 (103).
(83) Remove self-locking nut (104) and washer (105) from
voltage regulator (102).
(84) Position terminal lug TL35 (106) on voltage regulator
(102) with washer (105) and self-locking nut (104).
(85) Tighten self-locking nut (104) to 20 lb-in. (2 N·m).
(86) Position boot on terminal lug TL35 (106).
3-46
Change 1
