TM 9-2320-365-102-21. VEHICLE OPERATION (CONT)CAUTION• Do not press ether start switch unless engine is cranking. Failure tocomply may result in damage to engine.• Do not use ether after the engine has reached idle speed (750 rpm) andis no longer in danger of stalling. Failure to comply may result in damageto engine.NOTE• Continue to inject ether if engine has started but will not run without ether.• If outside air temperature is 32F to -25F (0C to -32C) perform step(6) and (7).(7) Press and hold ether start switch (8) for approximately three seconds and release fortwo seconds.(8) Repeat step (7) until engine has started, engine speed has increased over crankingspeed, and engine maintains speed.2-136 Change 1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
