TM 9-2320-365-10Table 3-2. Troubleshooting (Cont)MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTIONe17e. WATER TEMP GAGE DOES NOT ILLUMINATE (CONT).(g) Position main light switch auxiliary lever to OFF (para 2-21c).(h) Position main light switch main selector lever to OFF (para 2-21c).e17f. OIL PRESS GAGE DOES NOT ILLUMINATE.Check to see if WATER TEMP gage illuminates.(a) Position main light switch main selector lever to SER DRIVE (para 2-21c).(b) Position main light switch auxiliary lever to PNL BRT (para 2-21c) and observe if WATERTEMP gage illuminates.(c) Position main light switch auxiliary lever to OFF (para 2-21c).(d) Position main light switch main selector lever to OFF (para 2-21c).If WATER TEMP gage illuminates, notify Unit Maintenance.If WATER TEMP gage does not illuminate, check circuit breaker (CB70) on PDP to see if it istripped.(a) Remove PDP cover (para 3-13a).(b) If circuit breaker is tripped, push in to reset.(c) Install PDP cover (para 3-13b).(d) Position main light switch main selector lever to SER DRIVE (para 2-21c).(e) Position main light switch auxiliary lever to PNL BRT (para 2-21c) and observe if OILPRESS gage illuminates.(f) If OIL PRESS gage does not illuminate, notify Unit Maintenance.(g) Position main light switch auxiliary lever to OFF (para 2-21c).(h) Position main light switch selector lever to OFF (para 2-21c).e18. AUXILIARY PANEL, PERSONNEL HEATER, AND INSTRUMENT PANEL DO NOTILLUMINATE.Check circuit breaker (CB23) in PDP to see if it is tripped.(a) Remove PDP cover (para 3-13a).(b) Position main light switch to OFF (para 2-21c).(c) If circuit breaker is tripped, push in to reset.(d) Position main light switch to SER DRIVE (para 2-21c).(e) Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.(f) Position main light switch to OFF (para 2-21c).(g) Install PDP cover (para 3-13b).Change 1 3-37
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
