TM 9-2320-365-10
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear
protective goggles and gloves; use only in well ventilated area;
avoid contact with skin, eyes, and clothes, and do not breathe
vapors. Keep away from heat or flame. Never smoke when using
solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F
(38°C) and for Type II is 130°F (50°C). Failure to comply may result
in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately
get fresh air and medical help. If dry cleaning solvent contacts skin
or clothes, flush with cold water. If dry cleaning solvent contacts
eyes, immediately flush eyes with water and get immediate medical
attention.
Failure to comply may result in serious injury to
personnel.
9. Lubricate front lifting beams monthly. Remove two retaining pins from front lifting
beam. Pull front lifting beam out as far as it will go. Clean with dry cleaning solvent.
Lubricate top, bottom, and sides of lifting beam with GAA. Push front lifting beam
back in to housing. Install two retaining pins in front lifting beam.
10. Lubricate spreader bars monthly. Remove hitch pin and retaining pin from spreader
bar. Pull spreader bar out as far as it will go. Clean with dry cleaning solvent.
Lubricate top, bottom, and sides of spreader bar with GAA. Push spreader bar back
in to housing. Install retaining pin and hitch pin in spreader bar.
11. Lubricate cab lift cylinder monthly with GAA.
Change 1
F-11/(F-12 Blank)