TM 9-2320-365-34-1WARNINGWear appropriate eye protection when workingunder vehicle due to the possibity of fallingdebris. Failure to comply may result in injury to personnel.CAUTIONMaintain engine rpm at 1,250-1,450 rpm whileperfoming pressure and flow test. Failure to comply may result in damage to equipment.HYDRAULIC FLOW AND PRESSURE TEST(15) Disconnect pressure hose from pressure/flowkit from circuit B tube.(16) Disconnect circuit B pressure hose from pressure/flow kit.(17) Connect circuit B pressure hose to circuitB tube.(18) Remove drain pan from under winch controlvalve.(1) Position drain pan under winch control valve.(2) Disconnect circuit B pump pressure hosefrom circuit B tube.(3) Connect pressure hose to pressure/flow kit.(4) Connect pressure hose from pressure/flowkit to circuit B tube.(5) Completely open pressure/flow kit load valve.(6) Start and run engine until ormal operating temperature is reached (TM 9-2320-365-10).(7) Engage PTO (TM 9-2320-365-10)(8) Set engine speed with manual throttlecontrol to 1,350 rpm.(9) Slowly close load valve on pressure/flow kituntil 2,500 psi (17,238 kPa) is reached and note flow on pressure/flow kit.(10) If flow is not 15-18 GPM (51-70 lpm) at 2,500 psi (17,238 kPa), replace single stage hydraulic pump (para 16-5).(11) Open load valve on pressure/flow kit.(12) Decrease engine speed with manual throttle control.(13) Disengage PTO (TM 9-2320-365-10).(14) Shut down engine (TM 9-2320-365-10).2-979
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
