Change 1 2-101TM 9-2320-365-34-1RESISTANCE TEST(1) Set multimeter to ohms.(2) Connect positive (+) probe of multimeterto pin 1 of turbine speed sensor.(3) Connect negative (-) probe of multimeterto pin 2 of turbine speed sensor and notereading on multimeter.(4) If resistance is less than 200 ohms or greater than 400 ohms, replace transmission turbine speed sensor (para 6-5).(5) If resistance is between 200 and 400 ohms, replace WTEC II TEPSS (TM 9-2320-365-20-3).(6) Connect internal wiring harness connector TSS to turbine speed sensor.(7) Install cover on control valve module with four screws.(8) Install control valve module (para 7-10).(9) Connect adapter cable 24-pin connector tointernal wiring harness 24-pin connector.(10) Tighten screw in adapter cable 24-pinconnector.(11) Connect batteries (TM 9-2320-365-20-3).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
