KNOWN INFO                         TEST OPTIONS            Continuity Test or STE/ICE-R Test #91     REASON FOR QUESTION     Replace transmission external wiring harness (para 6-7). WARNING       CAUTION       Read WARNING and CAUTION on following page. START YES c4. WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN       CODE 22 SUB CODE 16 1. TM 9-2320-365-34-1 2-112          Change 1 NO Faulty transmission external wiring harness. Faulty output speed sensor. Faulty transfer case wiring harness. Faulty WTEC II TEPSS.        POSSIBLE PROBLEMS        Is continuity present from connector P119-n to external wiring harness transfer case connector pin C? If continuity is not present, transmission external wiring harness is faulty. Circuit breaker OK. Batteries OK. WTEC II cab transmission harness OK. INITIAL SETUP   Equipment Condition     Engine shut down (TM 9-2320-365-10).     Batteries disconnected (TM 9-2320-365-20-3).   Tools and Special Tools     Tool Kit, Genl Mech (Item 68, Appendix B)     STE/ICE-R (Item 60, Appendix B)     Multimeter, Digital (Item 34, Appendix B)     Goggles, Industrial (Item 25, Appendix B)     Pan, Drain (Item 36, Appendix B)     Wrench, Torque, 0-200 lb-in. (Item 81, Appendix B)     Wrench Set, Socket (Item 75, Appendix B) Materials/Parts   Gasket (Item 41, Appendix F)   Oil, Lubricating (Item 46, Appendix C)   Wire, Elect, 50 ft (Item 94, Appendix C) Personnel Required     (2) References     TM 9-4910-571-12&P