Change 1 2-533TM 9-2320-365-34-1(1) Remove two screws and washers fromfront grille.(2) Remove screw and washer from frontgrille.(3) Remove front grille from cab.(4) Disconnect connector P119 fromconnector J119.(5) Disconnect external wiring harness31-pin connector from adapter cable31-pin connector.(6) Set multimeter to ohms.(7) Connect positive (+) probe of multimeterto connector P119-K.(8) Connect negative (-) probe of multimeterto external wiring harness 31-pinconnector pin g and note reading onmultimeter.(9) If continuity is not present, replacetransmission external wiring harness(para 6-7).(10) Connect positive (+) probe of multimeter to connector P119-K.CONTINUITY TESTInspect connector pins/sockets for damage,corrosion, and serviceability. Check thatconnector pins are not pushed back andare capable of making good contact.NOTEUse care when testing electrical connectors.Do not damage connector pins or socketswith multimeter probes. Failure to complymay result in damage to equipment.Loose or dirty connectors may causeintermittent loss of power to transmissionECU and diagnostic codes to be logged.Ensure that all connectors are clean and tightbefore performing troubleshooting. Failure tocomply may result in incorrect test results.CAUTIONEnsure exhaust system is cool before performing troubleshooting. Failure to comply may result in injury to personnel.Wear appropriate eye protection when workingunder vehicle due to the possibility of fallingdebris. Failure to comply may result in injury to personnel.WARNING(11) Connect negative (-) probe of multimeterto all other pins in connector P119 andnote reading on multimeter.(12) Connect negative (-) probe of multimeterto ground and note reading on multimeter.(13) If continuity is present, transmissionexternal wiring harness is shorted; replacetransmission external wiring harness(para 6-7).CONTINUITY TEST (Cont)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business