TM 9-2320-365-34-1
2-3. REPAIR PARTS
Mandatory replacement parts are listed in Appendix F. Repair parts are listed and illustrated in the RPSTL, TM 9-
2320-365-24P, covering Unit, Direct Support, and General Support repair parts and special tools for the vehicle.
Section II. SERVICE UPON RECEIPT
2-4. UNPACKING AND DEPROCESSING
WARNING
Heavy objects/loads, such as tool boxes and heavy parts, must always be carried on the floor
with the weight distributed as equally as possible between left and right sides of M1079 van.
Failure to comply decreases the stability of the M1079 van and will increase the likelihood of a
rollover.
Heavy cabinets must always be mounted as low as possible with the weight distributed as
equally as possible between left and right sides of M1079 van. Remember to consider the
weight of the items that will be stored in the cabinets. Failure to comply decreases the stability
of the M1079 van and will increase the likelihood of a rollover.
Always keep in mind, when placing items inside the M1079 van, that heavier items must always
be positioned as low as possible and the weight distributed as equally as possible between left
and right sides of M1079 van. Failure to comply decreases the stability of the M1079 van and
will increase the likelihood of a rollover.
a. Unpacking. Upon receipt of a new vehicle, the receiving organization must see if it has been properly
prepared for service and is in good condition. Inspect all assemblies, subassemblies, and accessories to be sure
they are in proper working order (TM 9-2320-365-10). Secure, clean, and correctly adjust and/or lubricate as
needed (TM 9-2320-365-20). Check all tools and equipment to be sure every item is accounted for (TM 9-2320-
365-10-HR) in good condition, clean and properly mounted or stowed (TM 9-2320-365-10).
b. Deprocessing. Read "Processing and Deprocessing Record of Shipping, Storage and Issue of Vehicles and
Spare Engines" tag, (DD Form 1397) and follow all precautions checked. This tag should be attached to the
steering wheel or manual throttle control lever.
2-5. HAND RECEIPT MANUAL AND INVENTORY OF EQUIPMENT
When a new vehicle is first received by the using organization, it is necessary to inventory the vehicle equipment.
For detailed procedures, refer to Hand Receipt Manual, TM 9-2320-365-10-HR.
2-6. SERVICE BEFORE OPERATION
a. General.
(1) Refer to TM 9-2320-365-10 for operating instructions for the vehicle.
2-2
