Change 1 2-681TM 9-2320-365-34-1CONTINUITY TESTCAUTIONUse care when disconnecting wiring harnessconnectors. Failure to comply may resultin damage to equipment.(1) Remove control valve module (para 7-10).(2) Remove four screws and cover fromcontrol valve module.(3) Disconnect internal wiring harnessconnector A from A solenoid.(4) Set multimeter to ohms.(5) Connect positive (+) probe of multimeterto internal wiring harness 24-pin connectorpin A1.(6) Connect negative (-) probe of multimeterto internal wiring harness connector Apin A and note reading on multimeter.(7) If continuity is not present, replacetransmission internal wiring harness(para 7-13).(8) Connect positive (+) probe of multimeterto internal wiring harness 24-pin connectorpin A1.(9) Connect negative (-) probe of multimeterto all other pins in internal wiring harness24-pin connector, except pins A2, D1, andH1, and note reading on multimeter.(10) Connect negative (-) probe of multimeterto ground and note reading on multimeter.(11) If continuity is present, transmissioninternal wiring harness is shorted; replacetransmission internal wiring harness(para 7-13).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
