TM 9-2320-365-34-1Change 1 2-787CONTINUITY TESTCAUTIONUse care when disconnecting wiring harnessconnectors. Failure to comply may result indamage to equipment.(1) Remove control valve module (para 7-10).(2) Remove four screws and cover fromcontrol valve module.(3) Disconnect internal wiring harnessconnector F from F solenoid.(4) Set multimeter to ohms.(5) Connect positive (+) probe of multimeterto internal wiring harness 31-pin connectorpin E.(6) Connect negative (-) probe of multimeterto internal wiring harness connector Fpin A and note reading on multimeter.(7) If continuity is not present, replacetransmission internal wiring harness(para 7-13).(8) Connect positive (+) probe of multimeterto internal wiring harness 31-pin connectorpin E.(9) Connect negative (-) probe of multimeter toall other pins in internal wiring harness31-pin connector and note reading onmultimeter.(10) Connect negative (-) probe of multimeter toground and note reading on multimeter.(11) If continuity is present, transmissioninternal wiring harness is shorted; replacetransmission internal wiring harness(para 7-13).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
