TM 9-2320-365-34-2
24-2. REAR AXLE DIFFERENTIAL CARRIER REPAIR (CONT)
NOTE
•
Perform steps (38) and (39) only if a new pinion drive and drive gear set were installed. If old
pinion drive and ring gear set is installed, go to step (40).
•
The pinion cone variation number can be either 0.001 in. or 0.01 mm. For example, PC +4
equals +0.004 in., PC -.05 mm equals -0.05 mm.
(38) If pinion cone variation number recorded in step (15) of disassembly is negative, subtract it from the thickness of
the shims. If number is positive, add it to the thickness of the shims. Refer to Table 24-2 Pinion Cone Variation
Chart.
NOTE
The value obtained from step (38) is the thickness of the new shims to be installed. Use as
many shims as required to equal the value obtained from step (38).
(39) If pinion cone variation number recorded in step (19) of assembly is negative, subtract it from value the thickness
of the shims. If number is positive, add it to the thickness of the shims. Refer to Table 24-2 Pinion Cone
Variation Chart.
Table 24-2. Pinion Cone Variation Chart
PINION CONE VARIATION NUMBER
EQUIVALENT MEASUREMENT
PC +1 through PC +9
+0.001 in. through +0.009 in.
+1 through +9
PC -1 through PC -9
-0.001 in. through -0.009 in.
-1 through -9
PC +.01 mm through +.09 mm
+0.01 mm through +0.09 mm
+.01 mm through +.09 mm
PC -.01 mm through PC -.09 mm
-0.01 mm through -0.09 mm
-.01 mm through -.09 mm
24-16
