TM 9-2320-365-34-2
6-3. STARTING MOTOR REPAIR (P/N M0017730MD) (CONT)
b. Cleaning/Inspection.
WARNING
• Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and gloves; use
only in well ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe vapors.
Keep away from heat or flame. Never smoke when using solvent; the flashpoint for Type I Dry
Cleaning Solvent is 100 ° F (38 ° C) and for Type II is 130 ° F (50 ° C). Failure to comply may result
in serious injury or death to personnel.
• If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical help.
If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes, immediately
flush eyes with water and get immediate medical attention. Failure to comply may result in injury
to personnel.
• Compressed air used for cleaning purposes will not exceed 30 psi (207 Kpa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure
to comply may result in injury to personnel.
(1) Clean all metal parts with dry cleaning solvent and dry
using compressed air prior to inspection.
NOTE
• Replace any part that fails visual inspection or
size measurement requirements.
• Replace armature if continuity is present
between
splined
end
of
armature
and
commutator contacts.
(2) Test for shorts between splined end (1) of armature
(2) and all commutator contacts (3).
6-18
