TM 9-2320-365-34-2
Section II. MAINTENANCE PROCEDURES
3-2. DRESSED ENGINE UNPACKING/PACKING
This task covers:
a. Unpacking
b. Packing.
INITIAL SETUP
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Torque, 0-150 lb-in. (Item 79, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Sling, Multiple Leg (TM 9-2320-365-20)
Sling, Engine and Transmission, Motor Vehicle (Item
49, Appendix B)
Stand, Engine Transport (Item 59, Appendix B)
Wrench Set, Socket (Item 75, Appendix B)
Materials/Parts
Rag, Wiping (Item 59, Appendix C)
Tape, Duct (Item 84, Appendix C)
Desiccant (5) (Item 26, Appendix C)
Lockwasher (41) (Item 104, Appendix F)
Gasket (Item 29, Appendix F)
Personnel Required
(2)
a. Unpacking.
WARNING
Ensure all pressure is released from
engine container. Failure to comply may
result in injury to personnel.
(1) Depress and hold air release button (1) on engine
container breather valve (2) until all pressure is released.
WARNING
Engine
container
cover
weighs
approximately 130 lbs (59 kgs). Attach a
suitable lifting device prior to unpacking.
Failure to comply may result in injury to
personnel or damage to equipment.
(2) Remove 24 nuts (3), lockwashers (4), and screws (5)
from engine container cover (6). Discard lockwashers.
NOTE
Step (3) requires the aid of an assistant.
(3) Lift engine container cover (6) from engine container
base (7).
(4) Remove gasket (8) from engine container base (7).
Discard gasket.
3-2
