TM 9-2320-365-34-2
15-5. M1081 CAB REAR WALL REPLACEMENT/REPAIR
This task covers:
a. Removal
b. Disassembly
c. Assembly
d. Installation
e. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
M1081 cab roof removed (TM 9-2320-365-20-4).
M42 Alarm removed, if equipped (TM 9-2320-365-10).
Spare tire lowered (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Socket Set, Socket Wrench (Item 51, Appendix B)
Wrench Set, Socket (TM 9-2320-365-20)
Socket Wrench Attachment, Screwdriver (TM 9-2320-
365-20)
Wrench, Torque, 0-200 lb-in. (Item 81, Appendix B)
Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B)
Wrench, Torque, 0-75 lb-in. (Item 86, Appendix B)
Tool Kit, Blind Rivet (Item 66, Appendix B)
Materials/Parts
Washer, Flat (Item 91, Appendix C)
Nut, Self-locking (Item 52, Appendix C)
Seal (2) (30 in. (750mm)) (Item 254, Appendix
F)
Screw, Captive (12) (Item 253, Appendix F)
Insulation Panel (Item 65, Appendix F)
Insulation Panel (Item 66, Appendix F)
Insulation Panel (Item 67, Appendix F)
Insulation Panel (Item 68, Appendix F)
Insulation Panel (Item 69, Appendix F)
Insulation Panel (Item 70, Appendix F)
Lubricating Oil, Engine (Item 48, Appendix C)
Personnel Required
(2)
a. Removal.
(1) Release three latches (1) on clamps (2).
(2) Remove davit (3) from three clamps (2).
(3) Remove dustcap (4) from connector J62 (5).
(4) Remove screw (6) and dustcap (4) from cab rear wall
(7).
(5) Remove three screws (8) and connector J62 (5) from
cab rear wall (7).
15-95
