ENGINE TO MAINTENANCE STAND MOUNTING

/.5tonv1-2/TM-9-2320-365-34-2 M10787 Series 2-1/2-Ton 4x4 Light Medium Tactical Vehicle (LMTV) Manual
Page Navigation
862

TM 9-2320-365-34-2 Section II. MAINTENANCE PROCEDURES 20-2. ENGINE TO MAINTENANCE STAND MOUNTING This task covers: a. Mounting b. Demounting c. Follow-On Maintenance INITIAL SETUP Equipment Conditions Engine assembly removed (para 3-3). Starter removed (TM 9-2320-365-20-3). Throttle position sensor cable assembly removed (TM 9-2320-365-20-3). Fuel/water separator removed (TM 9-2320-365- 20-3). Fuel filter base removed (TM 9-2320-365-20-3). Air compressor removed (para 11-2). Engine bracket removed (para 3-5). Tools and Special Tools Tool Kit, Genl Mech (Item 68, Appendix B) Wrench, Torque, 0-175 lb-ft (Item 80, Appendix B) Engine Stand Bracket (Item 6, Appendix D) Stand, Maintenance, Engine (TM 9-2320-365-20) Materials/Parts Packing, Preformed (Item 204, Appendix F) Gasket (Item 55, Appendix F) Packing, Preformed (Item 195, Appendix F) Personnel Required (2) a. Mounting. (1) Remove bolt (1) and washer (2) from fuel tube clip (3). (2) Disconnect fuel tube (4) from 90-degree fitting (5). (3) Remove preformed packing (6) from 90-degree fitting (5). Discard preformed packing. 20-2 Change 1

Privacy Statement
Press Release
Contact