TM 9-2320-365-34-2
3-3. ENGINE ASSEMBLY REPLACEMENT (CONT)
(156) Remove nut (203.1) from starter solenoid (203.2).
(157) Position terminal lug TL26 (203.3) on starter solenoid
(203.2) with nut (203.1).
(158) Tighten nut (203.1) to 31 lb-in. (4 N·m).
(159) Remove nut (203.4) from starter solenoid (204).
(160) Position terminal lugs TL12 (205) and TL55 (206) on
starter solenoid (204) with nut (203.4).
(161) Tighten nut (203.4) to 30 lb-ft (41 N·m).
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. Keep
away from open fire and use in a well-
ventilated area.
If adhesive, solvent, or
sealing compound gets on skin or clothing,
wash immediately with soap and water.
Failure to comply may result in injury to
personnel.
(160.2) Apply adhesive on terminal lug TL26 (203.3), solenoid
terminal (203.2), and nut (203.1).
(160.3) Apply adhesive on terminal lugs TL12 (205), TL55 (206),
solenoid terminal (204), and nut (203.4).
(161) Connect power steering return hose (207) to tube (208)
with clamp (209).
(162) Connect power steering pressure hose (210) to 90-
degree fitting (211).
(163) Position power steering reservoir bracket (212) on
bracket (213) with two screws (214) and self-locking nuts
(215).
(163.1) Tighten two self-locking nuts (215) to 31-39 lb-ft (43-53
N·m).
3-56
Change 1
