TM 9-2320-365-10
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e21.
AUXILIARY PANEL DOES NOT ILLUMINATE (CONT).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If auxiliary panel still does not illuminate, notify Unit Maintenance.
e22.
HIGH ENGINE TEMPERATURE INDICATOR DOES NOT ILLUMINATE.
Check circuit breaker (CB77) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-13a).
(b)
Position main light switch to OFF (para 2-21c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-21c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If high engine temperature indicator still does not illuminate, notify Unit Maintenance.
e23.
CENTRAL TIRE INFLATION SYSTEM (CTIS) OVERSPEED INDICATOR DOES NOT
ILLUMINATE.
Check circuit breaker (CB40) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-13a).
(b)
Position main light switch to OFF (para 2-21c).
(c)
If circuit breaker is tripped, push in to reset.
(d)
Position main light switch to SER DRIVE (para 2-21c).
(e)
Check circuit breaker to see if it tripped. If circuit breaker is tripped, notify Unit Maintenance.
(f)
Position main light switch to OFF (para 2-21c).
(g)
Install PDP cover (para 3-13b).
(h)
If CTIS overspeed indicator still does not illuminate, notify Unit Maintenance.
e24.
CHEMICAL DETECTOR INDICATOR DOES NOT ILLUMINATE.
Check circuit breaker (CB30) in PDP to see if it is tripped.
(a)
Remove PDP cover (para 3-13a).
(b)
Position main light switch to OFF (para 2-21c).
Change 1
3-39