TM 9-2320-365-34-1
D-35. LANYARD ASSEMBLIES P/N 12418763 AND 12420196 FABRICATION
Make the following lanyard assemblies from bulk cable material, sleeves, and tab material and assemble according to
Figure D-49. Lanyard Assembly. The following parts list identifies part numbers and lengths of cut pieces.
Item
Part Number
Material Description
Size
Qty
1
MIL-W-83420 Type 1,
Comp B
1/16 in. stranded wire
cable
4 in. (102 mm)
1
2
MS51844-22
Sleeve
2
3
N/A
Tab, Stainless Steel ASTM
A617
0.06 in. (1.5 mm) X 0.37 in. (9.5 mm) X
1.25 in. (32 mm)
1
Figure D-49. Lanyard Assembly
a. All dimensions are in inches (millimeters).
b. Make from bulk cable and flat steel material as identified in parts list.
c. Drill two 0.19 in. (4.8 mm) diameter holes through tab material as shown in Figure D-49 Lanyard Assembly.
d. De-burr and remove sharp edges.
e. Bend tab as shown in Figure D-49 Lanyard Assembly.
f. Form loops on cable ends and insert sleeve material over cable on one end of cable and over cable and through
sleeve at other end of cable as shown in Figure D-49. Lanyard Assembly.
g. Crimp two sleeves over cable ends.
D-60
