• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN           CODE 41, 42, 44, 45, AND/OR 69 SUB CODE 21 (SERIAL NUMBER 6510032369           AND HIGHER)
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN           CODE 41, 42, 44, 45, AND/OR 69 SUB CODE 21 (SERIAL NUMBER 6510032369           AND HIGHER) (CONT)

/.5tonv1-2/TM-9-2320-365-34-1 M1078 Series 2-1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  384    385    386    387    388  389  390    391    392    393    394  
CONTINUITY TEST CAUTION WARNING TM 9-2320-365-34-1 Change 1          2-345 Wear appropriate eye protection when working under vehicle due to the possibility of falling debris.  Failure to comply may result in injury to personnel. Ensure exhaust system is cool before performing troubleshooting. Failure to comply may result in injury to personnel. Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. Loose or dirty connectors may cause intermittent loss of power to transmission ECU and diagnostic codes to be logged. Ensure that all connectors are clean and tight before performing troubleshooting.  Failure to comply may result in incorrect test results. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE   (1)  Remove two screws and washers from         front grille.   (2)  Remove screw and washer from front         grille.   (3)  Remove front grille from cab.   (4)  Disconnect connector P119 from         connector J119.   (5)  Disconnect external wiring harness         31-pin connector from internal wiring         harness 31-pin connector.   (6)  Set multimeter to ohms.   (7)  Connect positive (+) probe of multimeter         to connector P119-F.   (8)  Connect negative (-) probe of multimeter to         external wiring harness 31-pin connector         pin E and note reading on multimeter.   (9)  If continuity is not present, replace         transmission external wiring harness         (para 6-7). (10)  Connect positive (+) probe of multimeter         to connector P119-F. (11)  Connect negative (-) probe of multimeter to         all other pins in connector P119 and note         reading on multimeter. (12)  Connect negative (-) probe of multimeter         to ground and note reading on         multimeter. (13)  If continuity is present, transmission         external wiring harness is shorted; replace         transmission external wiring harness                (para 6-7). CONTINUITY TEST (Cont)







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.