• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 43 SUB CODE 26 (PRIOR TO SERIAL NUMBER 6510032369) (CONT) - TM-9-2320-365-34-1_634
WTEC II TRANSMISSION ECU PUSHBUTTON SHIFT SELECTOR (TEPSS) DISPLAYS MAIN         CODE 43 SUB CODE 26 (PRIOR TO SERIAL NUMBER 6510032369) (CONT) - TM-9-2320-365-34-1_636

/.5tonv1-2/TM-9-2320-365-34-1 M1078 Series 2-1/2-Ton 4x4 Light Medium Tactical Vehicles (LMTV) Manual
Page Navigation
  590    591    592    593    594  595  596    597    598    599    600  
Change 1          2-549 TM 9-2320-365-34-1   (1)  Set multimeter to ohms.   (2)  Connect positive (+) probe of multimeter         to connector P119-A.   (3)  Connect negative (-) probe of multimeter         to external wiring harness 24-pin         connector pin H2 and note reading on         multimeter.   (4)  If continuity is not present, replace         transmission external wiring harness         (para 6-7).   (5)  Connect positive (+) probe of multimeter         to connector P119-A.   (6)  Connect negative (-) probe of multimeter         to all other pins in connector P119 and         note reading on multimeter.   (7)  Connect negative (-) probe of multimeter         to ground and note reading on multimeter.   (8)  If continuity is present, transmission         external wiring harness is shorted; replace         transmission external wiring harness         (para 6-7).   (9)  Connect connector P119 to connector         J119. (10)  Position front grille on cab with washer         and screw. CONTINUITY TEST (11)  Position two washers and screws in front         grille. (12)  Tighten screw to 48-60 lb-in. (5-7 N·m). (13)  Tighten two screws to 24 lb-in. (3 N·m).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.