TM 9-2320-365-34-2(15) Install seal (14) on access cover (15).CAUTIONWasher bearing must be positioned withgrooves facing up and hole aligned with pinin steering knuckle.(16) Install washer bearing (16) on access cover (15).(17) Position access cover (15) on steering knuckle (3) withfour washers (17) and screws (18).(18) Tighten four screws (18) to 500-650 lb-ft (678-881 N·m).(19) Install grease fitting (19) on access cover (15).(20) Install dial indicator on front axle (2) so pointer contactssurface of pivoting arm (4).(21) Use floor jack and raise steering knuckle (3) to applypressure to access cover (15).(22) Set dial indicator to zero.(23) Lower floor jack from steering knuckle (3).NOTEEnd play should read between 0.005-0.015in. (0.0127-0.0381 cm).(24) Read end play on dial indicator.9-27
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business