TM 9-2320-365-34-2
10-3. REAR AXLE DIFFERENTIAL PINION SEAL, YOKE SEAL AND DRIVE YOKE
REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Engine shut down (TM 9-2320-365-10).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Puller Kit, Mechanical (Item 44, Appendix B)
Wrench Set, Socket, (Item 74, Appendix B)
Multiplier, Torque Wrench (Item 35, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Hammer, Soft Head (Item 28, Appendix B)
Socket Set, Impact (Item 50, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix
B)
Tools and Special Tools (Cont)
Sling, Cargo (Item 48, Appendix B)
Driver, Front and Rear Differential Yoke Seal (Item
45, Appendix D)
Driver, Differential Pinion Seal (Item 44, Appendix D)
Holding Bar, Pinion (TM 9-2320-365-20)
Materials/Parts
Grease, Automotive and Artillery (Item 36, Appendix
C)
Kit, Seal (Item 263.1, Appendix F)
Nut, Self-Locking (Item 144, Appendix F)
Screw (4) (Item 251.1, Appendix F)
Personnel Required
(2)
WARNING
Wear appropriate eye protection when
working under vehicle due the possibility
of falling debris. Failure to comply may
result in injury to personnel.
a. Removal.
(1) Remove four screws (1) and two bearing cups (2) from
drive yoke (3). Discard screws.
(2) Slide drive shaft (4) from side to side and separate
universal joint (5) from drive yoke (3).
NOTE
Step (3) requires the aid of an assistant.
(3) Attach drive shaft (4) to frame (6).
Change 1
10-11
