TM 9-2320-365-34-2
16-6. POWER TAKEOFF (PTO) REPLACEMENT/REPAIR (CONT)
NOTE
Step (10) requires the aid of an assistant.
(10) Remove drive shaft (10) from frame (11).
(11) Position universal joint (12) on yoke (13) with two
bearing cups (14) and four screws (15).
NOTE
When correct torque is reached, bearing cap
screw small hex head will brake off.
(12) Tighten four screws (15).
NOTE
Perform steps (13) through (14.9) on vehicles
equipped with transmission oil cooler tubes.
Perform steps (13) and (14) on vehicles not
previously equipped with corrosive enhanced
fittings.
(13) Install preformed packing (16) on fitting (17).
(14) Install fitting (17) on transmission oil cooler (18).
(14.1) Install preformed packing (18.1) on fitting (17).
Change 1
16-40.3/(16-40.4 Blank)