TM 9-2320-365-34-2
20-3. CYLINDER HEAD REPAIR (CONT)
e. Assembly.
NOTE
Remove all cutting chips and debris from
cylinder head fuel galley. Use a cotton swab,
lightly coated with grease, to aid in removal
of any particles.
(1) Clean injector sleeve bores (1) in cylinder head (2).
(2) Clean injector sleeves (3).
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. Keep
away from open fire and use in a well
ventilated area.
If adhesive, solvent, or
sealing compound gets on skin or clothing,
wash immediately with soap and water.
Failure to comply may result in injury to
personnel.
(3) Spray dry cleaning solvent inside of each injector sleeve
bore (1) in cylinder head (2) and outside of each injector
sleeve (3).
(4) Spray primer inside of each injector sleeve bore (1) in
cylinder head (2) and outside of each injector sleeve (3).
20-18
