(1) Position stub shaft (1) on cylinder block (2) with three
(2) Tighten three bolts (3) to 33-47 lb-ft (45-65 N·m).
Ensure timing marks are aligned as noted
during removal. Failure to comply may result
in damage to equipment.
(3) Install bearing sleeve (4) and idler gear (5) with timing
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. Keep
away from open fire and use in a well
If adhesive, solvent, or
sealing compound gets on skin or clothing,
wash immediately with soap and water.
Failure to comply may result in injury to
(4) Place a bead of sealant on front gear housing (6) seating
surface (shaded area).