TM 9-2320-365-34-1 D-4.   CAB MAINTENANCE STAND Make the cab maintenance stand from steel plate, 2 inch by 4 inch and 4 inch by 4 inch lumber, and bolts, nuts and washers  according  to  the  following  instructions. Refer  to  the  parts  list  tables  and  figures   Figure  D-4.    Cab Maintenance Stand Angle Brackets and Straight Brackets,  Figure D-5.   Cab Maintenance Stand Base Angle Bracket Locations, Figure D-6.  Cab Maintenance Stand Base Fabrication, Figure D-7.  Cab Maintenance Stand Brace  Bracket  Locations,  Figure  D-8.    Cab  Maintenance  Stand  Brace  to  Base  Assembly,  Figure  D-9.  Cab Maintenance Stand Brace to Base Assembly, and Figure D-10.  Cab Maintenance Stand Assembly   for details. Item No. Item Description Size or Dimension Material Description Qty 1 Base, LH, RH 51½ x 3½ x 3½ 4X4 in. Lumber (MIL-STD-731) 2 2 Base Feet 10½ x 3½ x 3½ 4x4 in. Lumber 4 3 Base Spreaders 41 x 3½ x 1½ 2x4 in. Lumber 6 4 Brace, Mid, and Front Supports 15½ x 3½ x 3½ 4x4 in. Lumber 4 5 Brace, Rear Support 25 x 3½ x 3½ 4x4 in. Lumber 2 6 Support, Rear, Front, Middle 41 x 3½ x 3½ 4x4 in. Lumber 3 7 Brace Spreaders 44½ x 3½ x 1½ 2x4 in. Lumber 2 8 Pads 6 x 3½ x 1½ 2x4 in. Lumber 4 9 Bracket, Angle 3½ x 3½ x 1/8 1/8 in. Steel Angle Stock 6 10 Bracket, Straight 5½ x 3½ x 1/8 1/8 in. Steel Plate Stock 6 11 Bolt, 3/8 X 4 in. Carriage, NC 24 12 Bolt, 3/8 X 10 in. Carriage, NC 24 13 Washer, Flat, 3/8 in. 48 14 Lockwasher, 3/8 in. 48 15 Nut, Hex, 3/8 in. 48 D-8