Change 1          2-243 TM 9-2320-365-34-1 CONTINUITY TEST CAUTION WARNING Inspect connector pins/sockets for damage, corrosion, and serviceability.  Check that connector pins are not pushed back and are capable of making good contact. Wear appropriate eye protection when working under vehicle due to the possibility of falling debris.  Failure to comply may result in injury to personnel. Ensure exhaust system is cool before performing troubleshooting. Failure to comply may result in injury to personnel. Loose or dirty connectors may cause intermittent loss of power to transmission ECU and diagnostic codes to be logged. Ensure that all connectors are clean and tight before performing troubleshooting.  Failure to comply may result in incorrect test results. Use care when testing electrical connectors. Do not damage connector pins or sockets with multimeter probes.  Failure to comply may result in damage to equipment. NOTE   (1)  Remove two screws and washers from         front grille.   (2)  Remove screw and washer from front         grille.   (3)  Remove front grille from cab.   (4)  Disconnect connector P119 from         connector J119.   (5)  Disconnect external wiring harness         31-pin connector from internal wiring         harness 31-pin connector.   (6)  Set multimeter to ohms.   (7)  Connect positive (+) probe of multimeter         to connector P119-C.   (8)  Connect negative (-) probe of multimeter         to external wiring harness 31-pin         connector pin B and note reading on         multimeter.   (9)  If continuity is not present, replace         transmission external wiring harness         (para 6-7). (10)  Connect positive (+) probe of multimeter         to connector P119-C. (11)  Connect negative (-) probe of multimeter         to all other pins in connector P119 and         note reading on multimeter. (12)  Connect negative (-) probe of multimeter          to ground and note reading on multimeter. (13)  If continuity is present, transmission         external wiring harness is shorted; replace         transmission external wiring harness         (para 6-7). CONTINUITY TEST (Cont)