Change 1 2-503TM 9-2320-365-34-1CAUTIONUse care when disconnecting wiring harnessconnectors. Failure to comply may result in damage to equipment.CONTINUITY TEST(1) Loosen screw in adapter cable 24-pinconnector.(2) Disconnect adapter cable 24-pin connectorfrom internal wiring harness 24-pin connector.(3) Set multimeter to ohms.(4) Connect positive (+) probe of multimeter to adapter cable 31-pin connector pin E.(5) Connect negative (-) probe of multimeter to adapter cable 24-pin connector pin D3and note reading on multimeter.(6) If continuity is not present, replace transmission adapter cable assembly (para 6-8).(7) Connect positive (+) probe of multimeter to adapter cable 31-pin connector pin E.(8) Connect negative (-) probe of multimeterto all other pins in adapter cable 31-pinconnector and note reading onmultimeter. (9) Connect negative (-) probe of multimeter to ground and note reading on multimeter.(10) If continuity is present, transmissionadapter cable assembly is shorted; replace transmission adapter cable assembly (para 6-8).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
