CAUTION
TM 9-2320-365-34-1
Change 1 2-835
CONTINUITY TEST
Use care when disconnecting transmission
internal wiring harness connectors. Failure
to comply may result in damage to equipment.
(1) Remove valve body cover (para 8-2).
(2) Disconnect transfer case wiring harness
connector H from H solenoid.
(3) Set multimeter to ohms.
(4) Connect positive (+) probe of multimeter
to transfer case connector pin A.
(5) Connect negative (-) probe of multimeter
to transfer case wiring harness connector
socket A.
(6) If continuity is not present, replace
transfer case wiring harness (para 8-2).
(7) Connect positive (+) probe of multimeter
to transfer case connector pin A.
(8) Connect negative (-) probe of multimeter
to all other pins in transfer case connector
and note reading on multimeter.
(9) Connect negative (-) probe of multimeter
to ground and note reading on multimeter.
(10) If continuity is present, transfer case
wiring harness is shorted; replace transfer
case wiring harness (para 8-2).
