TM 9-2320-365-34-2
(16) Inspect two C1 pressure plates (9) for scoring.
(17) Measure thickness (A) of each C1 pressure plate (9),
minimum thickness at wear surface 0.246 in. (6.248
mm).
(18) Lay straight edge across each C1 pressure plate (9),
subtract measurement (B) from (A), maximum bend in
pressure plate 0.006 in. (0.152 mm).
(19) Inspect C2 pressure plate (10) for scoring.
(20) Measure thickness (C) of C2 pressure plate (10),
minimum thickness at wear surface 0.246 in. (6.248
mm).
(21) Lay straight edge across C2 pressure plate (10), subtract
measurement (D) from (C), maximum bend in pressure
plate 0.018 in. (0.457 mm).
(22) Inspect C2 spring (11) for broken or missing springs.
(23) Inspect C1 spring (12) for broken or missing springs.
(24) Inspect balance piston (13) for scuffing, nicks, and burrs.
(25) Inspect C1 piston (14) for scuffing, nicks, and burrs.
(26) Inspect C2 piston (15) for scuffing, nicks, and burrs.
(27) Inspect clutch hub (16) for scuffing, nicks, and burrs.
21-25
