TM 9-2320-365-34-2
(23) Position wiring harness (24), gasket (25), and cover plate
(26) on transfer case housing (2) with four screws (27).
(24) Tighten four screws (27) to 4-6 lb-ft (5-8 N·m).
(25) Position pressure relief valve (28), spring (29), and plug
(30) in oil pump (31).
(26) Tighten plug (30) to 18 lb-ft (24 N·m).
(27) Position shim(s) (32) and oil pump (31) on transfer case
housing (2) with eight bolts (33).
(28) Tighten eight bolts (33) to 44-55 lb-ft (60-75 N·m).
NOTE
Shim(s) are selected during bearing preload
adjustment (para 22-4.d) to compensate for
differences in drive gear end play. The initial
shim(s) should have a minimum thickness of
0.076 in. (1.930 mm).
(29) Position gasket (34), shim(s) (35), seal washer (36), and
idler gear cover (37) on transfer case housing (2) with
five bolts (38).
(30) Tighten five bolts (38) to 44-55 lb-ft (60-75 N·m).
(31) Position shim(s) (39), pressure relief ball (40), and
manifold (41) on transfer case housing (2) with eight
bolts (42).
(32) Tighten eight bolts (42) to 44-55 lb-ft (60-75 N·m)
22-19
