TM 9-2320-365-34-29-6. STEERING KNUCKLE MECHANISM REPLACEMENT (CONT)(3) Support steering knuckle (3) with floor jack.(4) Use floor jack to raise steering knuckle (3) and removepressure from pivoting arm (4).(5) Install seal (5) on pivoting arm (4).(6) Install grease fitting (6) on pivoting arm (4).(7) Support steering knuckle (3) with floor jack.NOTEScrews used to position the pivoting arm aretightened finger tight until pivoting arm binds.(8) Position pivoting arm (4) on steering knuckle (3) withthree washers (7) and screws (8).NOTEThe gap measured in step (9) is the requiredthickness of the shim pack to be installed.(9) Measure and record the gap between the pivoting arm(4) and steering knuckle (3).(10) Remove three screws (8), washers (7), and pivoting arm(4) from steering knuckle (3).(11) Position shim(s) (9) and pivoting arm (4) on steeringknuckle (3) with three washers (7) and screws (8).(12) Position bracket (10) on pivoting arm (4) with washer(11), washer (12), and screw (13).(13) Tighten three screws (8) and screw (13) to 500-650 lb-ft(678-881 N·m).(14) Lower floor jack from steering knuckle (3).9-26
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
