TM 9-2320-365-34-29-6. STEERING KNUCKLE MECHANISM REPLACEMENT (CONT)NOTEPerform steps (25) through (31) if end play isnot between 0.005-0.015 in. (0.0127-0.0381cm).(25) Use floor jack and raise steering knuckle (3) to applypressure to access cover (15).(26) Remove screw (13), washer (12), bracket (10), andwasher (11) from pivoting arm (4).(27) Remove three screws (8), washers (7), pivoting arm (4),and shim(s) (9) from steering knuckle (3).NOTEShim(s) are added to decrease end play orremoved to increase end play.(28) Remove or add shim(s) (9) to obtain correct end play.(29) Position shim(s) (9) and pivoting arm (4) on steeringknuckle (3) with three washers (7), and screws (8).(30) Position bracket (10) on pivoting arm (4) with washer(11), washer (12) and screw (13).(31) Tighten three screws (8) and screw (13) to 500-650 lb-ft(678-881 N·m).(32) Perform steps (20) through (31) to determine if end playis correct.(33) Remove dial indicator from front axle (2).(34) Remove floor jack from steering knuckle (3).9-28
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
