TM 9-2320-365-34-2
14-7. STABILIZER MOUNTING BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Conditions
Rear stabilizer bar removed (TM 9-2320-365-20-3).
Tools and Special Tools
Tool Kit, Genl Mech (Item 68, Appendix B)
Wrench, Impact, Electric (Item 77, Appendix B)
Socket Set, Impact (Item 50, Appendix B)
Wrench, Torque, 0-600 lb-ft (Item 85, Appendix B)
Tools and Special Tools (Cont)
Wrench Set, Socket (Item 74, Appendix B)
Goggles, Industrial (Item 25, Appendix B)
Materials/Parts
Bolt (6) (Item 6, Appendix F)
Nut, Self-Locking (6) (Item 134, Appendix F)
WARNING
Wear appropriate eye protection when
working under vehicle due to the
possibility of falling debris. Failure to
comply may result in injury to personnel.
a. Removal.
CAUTION
When removing bolts, continuous removal of
collars is mandatory. Failure to comply will
result in seizing of collar to bolt.
NOTE
Left and right side stabilizer mounting
brackets are removed the same way. Right
side shown.
Remove three collars (1), bolts (2), and mounting bracket
(3) from frame (4). Discard collars and bolts.
14-36
